Zyxel Zyxel C1000z: Bridging Guide/ Entering PPPoE

Discus and support Zyxel Zyxel C1000z: Bridging Guide/ Entering PPPoE in XboX Networking Hardware to solve the problem; Zyxel (Modems/Gateways) Zyxel C1000z: Bridging Guide/ Entering PPPoE Login Information Gateway: 192.168.0.1 Username: admin Password: (located on... Discussion in 'XboX Networking Hardware' started by XB1R Hydros, Jun 27, 2014.

  1. XB1R Hydros
    XB1R Hydros Guest

    Zyxel Zyxel C1000z: Bridging Guide/ Entering PPPoE


    Zyxel (Modems/Gateways) Zyxel C1000z: Bridging Guide/ Entering PPPoE
    Login Information



    • Gateway: 192.168.0.1
    • Username: admin
    • Password: (located on the bottom of the device)


    Entering PPPoE

    Note: You will need the have the PPPoE information beforehand. Contact your ISP if you need to collect this information.



    1. Connect a computer to the gateway with an Ethernet cable.
    2. Open a web browser on a computer.
    3. Type the gateway address: 192.168.0.1 into the web address bar, select
      apply.
    4. This will take you to a login page, type admin for the username and password (located on the bottom of the device).
    5. Select Advanced Setup located on the left in red.
    6. Select WAN Settings from the left hand column. This option is located under the “IP Addressing” section.
    7. Under the “select the ISP protocol” Select the PPPoE option.
    8. Enter the PPP Username.
    9. Enter the PPP Password.
    10. Enter the same password into the Confirm PPP Password box.
    11. Verify PPP Auto Connect is enabled.
    12. Verify PPP Credentials Not Required is disabled.
    13. Verify Dynamic IP is selected.
    14. Verify Dynamic DNS is selected.
    15. Select the Apply button.
    16. The device will reboot.

    :)
     
    XB1R Hydros, Jun 27, 2014
    #1
  2. XB1R Hydros
    XB1R Hydros Guest
    Zyxel: Bridging Guide/ Entering PPPoE

    Zyxel (Modems/Gateways): Bridging Guide/ Entering PPPoE
    Login Information



    • Gateway: 192.168.1.1
    • Username: admin
    • Password: 1234
    Entering PPPoE

    Note: You will need the have the PPPoE information beforehand. Contact your ISP if you need to collect this information.



    1. Connect a computer to the gateway with an Ethernet cable.
    2. Open a web browser on a computer.
    3. Type the gateway address: 192.168.1.1 into the web address bar, select
      apply.
    4. This will take you to a login page, type admin for the username and type
      1234 for the password.
    5. Once logged in Select Network.
    6. Select the WAN Configuration option.
    7. Select the PPPoE option.
    8. Enter the PPP Username.
    9. Enter the PPP Password.
    10. Enter the PPPoE Service Name.
    11. Check the Enable NAT box.
    12. Check the Enable Full cone NAT box.
    13. Check the Enable Firewall box.
    14. Select the Next button. Continue to follow the prompts to save changes.
    15. The device will reboot.
     
    XB1R Hydros, Jun 27, 2014
    #2
  3. taidara
    taidara Guest
    Suddenly can't connect to Internet on 360

    Greetings Phane7!

    May I ask, is your ZyXEL C1000Z operating in bridge mode, or router/NAT mode?

    If it's possible, can you try connect your Xbox directly in to the ZyXEL C1000Z, and verify if you can connect properly to Live, or not.

    Thanks!
     
    taidara, Jun 27, 2014
    #3
  4. taidara Win User

    Suddenly can't connect to Internet on 360

    Greetings Phane7!

    May I ask, is your ZyXEL C1000Z operating in bridge mode, or router/NAT mode?

    If it's possible, can you try connect your Xbox directly in to the ZyXEL C1000Z, and verify if you can connect properly to Live, or not.

    Thanks!
  5. GMAN990 Win User

    ICMP Error

    Hi

    The Zyxel is a modem/router have you bridged the modem because if not you will suffer issues as you have two devices that are both NAT'ing otherwise , the Zyxel and the Netgear

    If you are not sure about bridging please contact your ISP as you may need additional details (PPPoE username/password) to enter into your Netgear before the change will work
  6. hoitoy Win User

    Connection interrupted

    Thanks for the reply I am running on a ZyXel C1000Z
  7. jmcode Win User

    Double NAT problems (I Think)

    Just to be clear, when you disabled DHCP on the Belkin, did you then connect the Zyxel to a LAN port on the Belkin? Did you verify the IP you used for port forwarding on the Zyxel was the new IP the Xbox One got from the Zyxel, not the one it had from the
    Belkin? If so, that should work unless something else is going on--can you get open NAT with the Xbox One directly wired to the Zyxel (with ports forwarded)? If not, that is a problem.

    As far as settings for bridge mode, I'm not familiar with your ISP so I'm not sue which setting is best on the Zyxel. On the Belkin, you need to match the current ISP setting on the Zyxel--i.e. if Zyxel is using PPPoE, set the Belkin to that. You will probably
    need to enter authentication (user/pass) depending on what that setting is...
  8. jmcode Win User

    Double NAT problems (I Think)

    Yes, the Zyxel is a gateway (modem+router), and you have problematic double NAT as a result. If you have access to the right settings, you can put the Zyxel in bridge mode as explained on page 22 of the manual here:

    ftp.zyxel.com/.../P-660RU-T1%20v3s_1.01.pdf

    This is the best solution, but your ISP may block those settings. If it does, and if it is unwilling to set it to bridge mode for you, another option is to disable DHCP on the Belkin and connect the Zyxel to a LAN port on the Belkin rather than WAN. Reboot
    Zyxel, Belkin, Xbox, and Xbox should get an IP from the Zyxel via DHCP (reserve this IP if the Zyxel supports that). You will then need to do all necessary port forwarding to the Xbox using the Zyxel unless the Zyxel properly implements UPnP (in which case
    enable that).
Thema:

Zyxel Zyxel C1000z: Bridging Guide/ Entering PPPoE

Loading...

  1. Zyxel Zyxel C1000z: Bridging Guide/ Entering PPPoE - Similar Threads - Zyxel Zyxel C1000z

  2. Zyxel C1000z: ZyXEL C3000Z Router/Modem isn't seen by Xbox One

    in XboX Networking Hardware
    Zyxel C1000z: ZyXEL C3000Z Router/Modem isn't seen by Xbox One: Zyxel C1000z: ZyXEL C3000Z Router/Modem isn't seen by Xbox One Do you have an original launch Xbox One? If so that may be the issue as that router uses 802.11ac and that is only supported on the S...

  3. Zyxel C1000z: Xbox One upnp failing

    in XboX Networking Hardware
    Zyxel C1000z: Xbox One upnp failing: Zyxel C1000z: Xbox One upnp failing As already mentioned, www.portforward.com is a fantastic resource. It lets you search for your specific router, and has step by step guides that are very clear,...

  4. Zyxel Zyxel C1000z: problems connecting to wifi

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: problems connecting to wifi: Zyxel (Modems/Gateways) Zyxel C1000z: problems connecting to wifi brand new xbox with built in wireless. sees wifi but keeps saying password is wrong...all other devices have no problem connecting...

  5. Zyxel Zyxel C1000z: Known Issues

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: Known Issues: Zyxel (Modems/Gateways) Zyxel C1000z: Known Issues login Information Gateway: 192.168.0.1 Username: admin Password: (located on the bottom of the device) Known Issues There are no...

  6. Zyxel Zyxel C1000z: Overview

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: Overview: Zyxel (Modems/Gateways) Zyxel C1000z: Overview Login Information Gateway: 192.168.0.1 Username: admin Password: (located on the bottom of the device) How to Find SSID (Network Name)...

  7. Zyxel Zyxel C1000z: How to Find SSID

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: How to Find SSID: Zyxel (Modems/Gateways) Zyxel C1000z: How to Find SSID (Network Name) ...router on the xbox needed reset. Would you know how to create multiple accounts, so the kids don't play as me?...

  8. Zyxel Zyxel C1000z: Wireless Security

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: Wireless Security: Zyxel (Modems/Gateways) Zyxel C1000z: Wireless Security Login Information Gateway: 192.168.0.1 Username: admin Password: (located on the bottom of the device) How To Find Wireless...

  9. Zyxel Zyxel C1000z: MAC Filtering

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: MAC Filtering: Zyxel (Modems/Gateways) Zyxel C1000z: MAC Filtering Login Information Gateway: 192.168.0.1 Username: admin Password: (located on the bottom of the device) MAC Filtering Connect a...

  10. Zyxel Zyxel C1000z: Change Wireless Channel

    in XboX Networking Hardware
    Zyxel Zyxel C1000z: Change Wireless Channel: Zyxel (Modems/Gateways) Zyxel C1000z: Change Wireless Channel Login Information Gateway: 192.168.0.1 Username: admin Password: (located on the bottom of the device) Change Wireless Channel...