Zyxel: Device Manual

Sorry for the delay!

I found the manual for the AMG1302-TSeries, and it seems that there is no later version of firmware than the one already installed. The software for this device can only be updated manually. ftp://ftp.zyxel.co.uk

Could you try restore your Zyxel gateway back to factory defaults. Before you do so, if you use PPPoA/PPPoE connectivity, you have to know the username and password assigned by your ISP, for the access and authentication method.

Unplug all existing devices from the Zyxel gatway (except for the power supply). Locate the reset button (at the back). Press and hold for 10 seconds. Power off the gateway for a couple of minutes. Plug in everything back up and wait one minute for it to connect
properly.

Reconfigure the Zyxel, (manually) such as, wireless security and UPnP.

Post back and let us know how that goes and we'll go from there.

What version of firmware are you running on your zyXEL NBG4615?

Visit zyXEL website and make sure this device is operating with the latest version of firmware.

Yes, the Zyxel is a gateway (modem+router), and you have problematic double NAT as a result. If you have access to the right settings, you can put the Zyxel in bridge mode as explained on page 22 of the manual here:

ftp.zyxel.com/.../P-660RU-T1%20v3s_1.01.pdf

This is the best solution, but your ISP may block those settings. If it does, and if it is unwilling to set it to bridge mode for you, another option is to disable DHCP on the Belkin and connect the Zyxel to a LAN port on the Belkin rather than WAN. Reboot
Zyxel, Belkin, Xbox, and Xbox should get an IP from the Zyxel via DHCP (reserve this IP if the Zyxel supports that). You will then need to do all necessary port forwarding to the Xbox using the Zyxel unless the Zyxel properly implements UPnP (in which case
enable that).

[quote user="XB1R Zeus"]

Login Information

• Default Gateway - gateway.2wire.net / 192.168.0.1 / 192.168.1.254 / 192.168.254.254
  
• Username - N/A
• Password - N/A (Windstream uses admin) (AT&T login pw: set by customer)

Click
HERE for Device Manual (AT&T)

[/quote]

Level 1

Posted 17 May 2013 12:21 AM

Login Information:

Gateway - 192.168.0.1

Username - (blank)

Password - admin

Device Manual: