Zhone Zhone 6212: Bridging Guide

With ISP distributel - a factory restore will set bridge mode, PPPOE login info will need to be entered into router to regain web access.

But a wireless bridge is something completely different, than having your Zhone gateway operating in "bridge" mode. A wireless bridge is a technique used to expand your existing network infrastructure (LAN) to an access Point. Two devices, where one creates
a bridged wireless network, from an existing network infrastructure, and allow an access point on the other side to connect to this bridged WLAN, and without the need to broadcast.

May I ask, have you been in Contact with your ISP (Internet Service Provider), and if they could help you configure your Zhone in bridge mode?

Keep us posted!

I forgot to say that the Zhone is in bridge mode or so I was told by North State.

I tried power cycleing but tat didn't help.

Hi,

Your problem is that you are "doubt NAT'ing"

Your Zhone is a router and running NAT

Your Juniper also runs NAT

Your best bet is to establish whether your can put the Zhone in "bridge mode" and hand off any PPPoE authentication (if your ISP uses it) to the Juniper

Then all you need to do is open the xbox live ports on the Juniper, but as it currently stands it won't work, the Xbox is hidden behind two many NAT'd layers.

when you put it in "full bridge mode" it disabled all router functionality ( assuming full bridge is correct) and with that, all the Port forwarding and other directions associated with the Zhone. the Netgear is what is running the show now and you can
try restoring that to factory, then adding things as needed if thats what you really want.