Zhone: Change Wireless Mode

But a wireless bridge is something completely different, than having your Zhone gateway operating in "bridge" mode. A wireless bridge is a technique used to expand your existing network infrastructure (LAN) to an access Point. Two devices, where one creates
a bridged wireless network, from an existing network infrastructure, and allow an access point on the other side to connect to this bridged WLAN, and without the need to broadcast.

May I ask, have you been in Contact with your ISP (Internet Service Provider), and if they could help you configure your Zhone in bridge mode?

Keep us posted!

I forgot to say that the Zhone is in bridge mode or so I was told by North State.

I tried power cycleing but tat didn't help.

yes it can! at least if you have the DD-WRT firmware

Check for obstructions that is close and could interfere with your router's signal strenght aswell as the external wireless network adapter. Try changing your router's wireless channel manually to a different channel (e.g. 11). Try changing/lowering the
wireless mode (802.11 mode. If your router's wireless security protocol is set to WEP try changing it to WPA or WPA2. Make sure UPnP is enabled.

Hi,

Your problem is that you are "doubt NAT'ing"

Your Zhone is a router and running NAT

Your Juniper also runs NAT

Your best bet is to establish whether your can put the Zhone in "bridge mode" and hand off any PPPoE authentication (if your ISP uses it) to the Juniper

Then all you need to do is open the xbox live ports on the Juniper, but as it currently stands it won't work, the Xbox is hidden behind two many NAT'd layers.