Xbox series X shutting down mid game and Xbox power button flashing

The rapid flashing of the power button on the Xbox Series X indicates that there may be an issue with the console's power supply or the internal hardware.

Hi,

If the Xbox power button on the console isn't flashing then you should fully shut down the console by holding the power button down until the unit goes off. Wait about 10 seconds, power back on and try syncing again.

Mine did the same thing. It wouldn't sync because the power button wasn't flashing.

Can you try performing a power cycle on your Xbox?

To do this:

For Series X|S

- Open Settings on Xbox.

- Select the General tab.

- Click on Power Options.

- Under the “Options” section, click the “Shutdown now” option.

- Click the “Shut down” button.

For Xbox One

Go to the Home screen.

Press the Menu button on the controller.

Select Settings.

Go to Sleep Mode & Start-Up

Select Turn Off/ Full Shut Down.

Once done, power up the console and see if the issue continues.

Hello Tim, sorry to hear you're having trouble.

I take it your console is an Xbox Series X as the game will not run on the Xbox One X. However, if you are using a Series X please try powercycling it by holding the power button on the console for 10 seconds till it shuts down then unplug it for 5 minutes. During this time unplug the modem/router for at least 60 seconds to clear any possible issues there.

When the internet is back up and running try again.

Hello ÚÑKÑØẄÑ ©, My name is David. I am an independent advisor, happy to help you today.

I'm sorry you're experiencing this issue with your Xbox Series X controller. Here are some possible solutions you could try:

Restart your Xbox console: Press and hold the power button on your Xbox console until it turns off. Next, disconnect the Xbox Series X from its power source. Turn off the Xbox controller and remove its batteries. Finally, connect and turn on your Xbox Series X.

Restart the controller: Press and hold the power button on the controller for several seconds until it turns off. Then turn it back on.

Pair the controller with the console again: Press and hold the sync button on the console until the power button flashes. Then, press and hold the sync button on the controller until the lights on the controller flash.

Best regards.