TP-Link TD-W8901G: IPv6 On Router And Hub help

I have the fios quantum gateway i am having the same issue ipv6 enabled but xbox one x still says ipv4

Just because its enabled in your router doesnt mean you have it.

Your ISP might not support it or your router might be configuered wrong.

Use a web browser on your PC and do an ipv6 test.

Go to https://test-ipv6.com/

It will give you a score out of 10 for your ipv6 connectivity.

My guess is you dont have 10 out of 10.

Had a similar issue to this, I went onto the web page of my internet browser and I was able to change my router as well as ipv4&6 settings in there

Router brand & model number: Tp link-TD-w8901g

Is UPnP Enabled? Yes/no/Unknown YES

Do you have a NAT error? If so, what is your NAT? not now. the nat was fixed

Who is your ISP(Internet Service Provider)? arnet

Hey Jack,

Port forwarding is performed differently depending on which router model you have. Most Internet Service Providers will be able to help you open ports if you can give them your consoles IP address and the ports you need open. To find instructions to do it
yourself, I recommend checking out
portforward.com

Thank you! This is valuable information.

[quote user="Ankau"]I got my friend to fill out his information too

Modem brand & model number: tp-link TD - 8840t

Router brand & model number: Linksys wrt1900ac[/quote]Can you ask your friend if their TP-Link TD-8840T is operating in bridge mode.

The TP-Link TD8840T is a combined xDSL modem with router/NAT built-in. So far so good, but since your friend also have an additional router/NAT (Linksys wrt1900ac) which terminates into an existing router/NAT (TP-Link TD-8840T), inbound/outbound traffic will
be NAT'd twice. Multiple levels of NAT in a home environment should be avoided.

Keep us posted!