TP-Link: Bridging Guide

TP-Link (Modems/Gateways): Bridging Guide
TP-Link TD-W8901G

Login Information:

Default Gateway – 192.168.1.1

Username – admin

Password – admin





Bridging Guide

1. Open a web browser and type http://192.168.1.1 into the address and press enter.
   
2. Enter “admin” for both the username and password when prompted.
3. Select Interface Setup from the menu at the top.
4. Select Internet from the resulting submenu.
5. In the Encapsulation section Choose Bridge Mode.
6. Click the SAVE button at the bottom of the screen.

:)

 

TP-Link: Bridging Guide

TP-Link (Modems/Gateways): Bridging Guide
TP-Link TD-8616



Login Information

Gateway - 192.168.1.1

Username - admin

Password - admin



Bridging Guide

1. Plug the computer into a LAN port via an ethernet cable.
2. Open a web browser.
3. Log into the device by entering the default gateway into the address bar of the internet browser (192.168.1.1).
   
4. The device will then prompt you to enter the username and password. The default username and password are "admin" and "admin".
   
5. Select Interface Setup from the tabs at the top.
6. Select Internet from the sub-menu.
7. Select Bridge Mode from the Encapsulation section of the page.
8. Click the SAVE button from the bottom of the page.

 

TP-Link: Bridging Guide

TP-Link (Modems/Gateways): Bridging Guide
TP-Link TD-W8960N

Login Information

Gateway - 192.168.1.1

Username - admin

Password - admin

Bridging Guide

1. Plug the computer into a LAN port via an ethernet cable.
2. Open a web browser.
3. Log into the device by entering the default gateway into the address bar of the internet browser (192.168.1.1).
   
4. The device will then prompt you to enter the username and password. The default username and password are "admin" and "admin".
   
5. Select Layer2 Interface from the menu on the left.
6. Select ATM Interface from the submenu.
7. Leave the VPI and VCI on their default values.
8. Select EoA from DSL Link Type options.
9. Select LLC/SNAP-BRIDGING.
10. The rest of the options should be left to the default values.
11. Click the Apply/Save button.