on delta. what does it mean xbox one two flashes white led power button then repeats? thx

The V2 does have a white led on it for showing sync. Mine does not flash when you press the sync button indicating the problem is probably with the hardware.

""Leave the system running until the XBOX briefly flashes the white LED"

The XBOX flashing the Nexus button (white LED) sounds suspiciously like the sequence when an update is in the Restart console phase, just prior to the Applying stage to complete the update.

Hi Ricardo,

Yes, that's the one. When I try to pair, I press the button until the little white LED on the adapter blinks and on the controller until the Xbox button flashes quickly.

1) is the power button for the Xbox BLACK, WHITE or CHROME?

1A) If it is CHROME, then bring the Xbox closer to the wireless router

1B) if BLACK or WHITE, what is the LED on the wireless adapter doing?

For the red dot issue read this:

General Hardware Failure
The specific type of hardware failure can be determined by a "hidden" error code:
- Turn the Xbox 360 on, and wait till the red dot is on
- Press and hold the sync up button (the small white one), while holding that button press the eject button.
- The LEDs will now blink the first number in the code (as described below).
- Release the eject button and press it again.
- The LEDs will now blink the second number of the code.
- Release the eject button and press it again.
- The LEDs will now blink the third number of the code.
- Release the eject button and press it again.
- The LEDs will now blink the fourth number of the code.
- Release the eject button and press it again.
- The LEDs will go back to the 3 flashing lights.

You should be able to determine the error code by looking at the lights.

Here is how you interpret the LEDs to get the code number:
* All four lights flashing - 0
* One light flashing - 1
* Two Lights flashing - 2
* Three lights flashing - 3

0001 - power supply problem
0002 - power supply problem
0003 - power problem could be the PSU could be the GPU/CPU, somehow the console isn't getting clean power from the power supply.
0010 - over heating
0011 - over heating
0012 - over heating
0013 - over heating
0020 - not yet known, possibly overheating
0021 - DVD Drive Time out - Can be caused by problems with a firmware flash. This is also speculated to some time be caused by a problem with the Southbridge chipset on the motherboard.
0022 - GPU Error / GPU Overheating
0102 - unknown error - literally means the console does not know what is wrong. Possibly a short or cold solder joint somewhere
0110 - not yet known
1022 - not yet known

Solution(s):
- Try restarting the console.
- If restarting the console does not resolve the behaviour, follow these steps:
* Turn the console off.
* Unplug all the power and AV cables from the console.
* Unplug the power cord from the wall socket.
* Firmly reconnect all the cables.
* Turn on the console.
- If these steps do not resolve the behaviour, turn the console off, remove the hard drive, and then turn on the console. If the red light is no longer displayed, turn the console off, re-attach the hard drive, and then turn on the console.