My guitar X-plorer when plugged in isn't working, the power button lits up as player 3 but...

It's likely died, it's 16 years old

Hello, try pressing and holding the power button until your console turns completely off and then power cycle it back on to see if that works, after that ensure that on your router the port that you’re plugged into is lit up verifying a connection. If
this is not lit up you may need to go into your router settings to open up some ports after calling your isp or router company.

Hi, using my powers of deduction and psychic abilities I suggest you check your guitar controller isn't having the guide button pressed constantly or the batteries may be going flat. Remove the batteries from the guitar when you're not using it would be
my suggestion to prevent this from happening again.

Hey Halo Brigadier! Can you tell me which wireless headset you own? Have you tried re-syncing your headset, or changing the sync position?



To sync, press and hold the sync button on the console (on the original console, the small circle button near the power button; on the S console, the small square button by the front USB ports) until the lights on the console power button start to spin.
Then press and hold the sync button on the wireless headset, located on the microphone. The lights should also start flashing on the headset.



Once they sync up, only one light will remain lit up on the headset, either 1, 2, 3, or 4. This indicates what player position the headset is synced to. For instance, if you are holding the first player controller (indicated by the upper-left light on the
controller) then you want your headset to have the 1 light lit up.



If the wrong number is lit up, tap the sync button on the headset until the proper number is lit up. If it seems to skip the number you want, you may have to turn all your controllers and wireless headsets off, and resync the headsets first, then the controllers.

Let us know how this works out for you!

Hi,

its not working when I hold the BIND that's on the right for me and then the EJECT button that's on the left it make a duhhh noise is the best way to describe it then I click to Xbox power button and it starts up like normal and also makes the startup noise
then the xbox light is lit for 3 or 4 secs and makes a shut down noise and then the light goes off. To be honest to me its like the xbox turn on as normal but doesn't know what to think or boot and it protocol is just to shut down it seems to not know the
command for the factory reset menu.... if I just click EJECT it will act normal like its ejecting a disk and the xbox light is lit and then goes off

Also someone said on a forum that if the Xbox HDMI is not plugged in it will just shut down is this true.

And no matter what if I click the power button it will always power up and do the same thing am just trying to rule out it its a power supply issue.

Regards,

Jordan