Linksys: MAC Filtering

Linksys (Routers): MAC Filtering
Login Information

• Gateway: 192.168.0.1
• Username: user
• Password: (provided by the ISP) (or left blank)

MAC Filtering

This feature is unavailable on this device

:)

 

Linksys: MAC Filtering

Linksys (Modems/Gateways): MAC Filtering
Login Information

• Gateway: 192.168.0.1
• Username: none (Leave blank)
• Password: admin

MAC Filtering

1. Connect a computer to the gateway with an Ethernet cable.
2. Open a web browser on a computer.
3. Type the address 192.168.0.1 into the web address bar.
4. Leave the username blank and type admin as the default password.
5. Click Ok to continue.
6. Click the Advanced option on the left hand side.
7. Click the MAC Filtering option on the top of the page.
8. Enter the device MAC address into the MAC Address Filters boxes.
   
9. Do this for each device on your network.
10. Click the Apply button.

Disable MAC Filtering

1. Connect a computer to the gateway with an Ethernet cable.
2. Open a web browser on a computer.
3. Type the address 192.168.0.1 into the web address bar.
4. Leave the username blank and type admin as the default password.
5. Click Ok to continue.
6. Click the Advanced option on the left hand side.
7. Click the MAC Filtering option on the top of the page.
8. Remove the device MAC address from the MAC Address Filters boxes.
   
9. Do this for each device on your network.
10. Click the Apply button.

 

Linksys: MAC Filtering

Linksys (Routers): MAC Filtering
Login Information

• Gateway -
  192.168.1.1
• Username - admin
• Password - admin

*Note* If Cisco Connect was used to configure the router then there are several other options for logging in.

One method is to use Cisco Connect again. Once the program has started click "Router Settings". Your network name and password are listed on the right. From here you can update this information should you choose.

Second method is from within Cisco Connect Choose router settings and then from the right column choose advanced and follow the on screen instructions to get to the web based interface.

MAC Filtering

1. Plug the computer into a LAN port via an ethernet cable.
2. Open a web browser.
3. Log into the router by entering the default gateway (192.168.1.1) into the address bar of the
   internet browser.
4. The router will then prompt for a user name and password. The default is that user name is “admin” and the password is “admin”.
   
5. From the tabs across the top choose Wireless.
6. Click on Wireless MAC Filter in the submenu.
7. Make sure the Radio Button next to Disable is selected.
8. Click Save Settings at the bottom.