Hitron: Port Forwarding to get an Open NAT

Hi there,

Thanks for the quick reply. Go ahead and add all the ports you have listed those are the correct 7 ports that must be added when

port forwarding. After you're done adding the ports make sure to save the changes and then restart your router. When you're restarting the router also perform a

power cycle on your Xbox. (when doing this make sure to turn on the Xbox once the network is back up)

Let us know how it goes.

What about the extra ports I have listed, should I keep them? Should I also restart my router or just leave it?

Hey there ImNegi,

Thank you for coming to the Forums with this question. It does not look like I was able to find your specific router while searching but I was able to find steps to different Hitron routers. It is possible that the steps might be similar between the routers.
Go ahead and click on the following link to the
Port Forward Site.

As far as the "Rules" you will be doing a new rule per port. You can always attempt to reach out to your Internet Service Provider for further assistance as they will know your device best.

I hope this helps.

Hi there,

I was not able to find your particular router but, I did find another Hiltron router. Hopefully this helps.

The following link will give you a guide as to how setup the port forwarding
HERE. Also, you can always contact customer support for assistance.

Have a great day.

Hello! First off i would reccommend setting a static ip address for your console(through network settings in advanced). Login to your router settings on a computer connected to the same network and use port forwarding to open the following ports

Udp: 88,500,3544,4500

Tcp & udp: 3074

Keeping in mind the new static ip address you made. Once done test your connection on Xbox.

Thanks.