: Double NAT and UPnP Issues with Orbi System

Hello N3CROMMAND3R,

Thank you for your post. I understand you are experiencing an issue with your Xbox One receiving a Double NAT type with your new router configuration. To troubleshoot this, please follow the steps on this article:

Double NAT detected in your network settings.

I hope this helps.

Hardwired the Xbox directly to the ATT "gateway" and it still shows strict NAT. I got the ports forwarded through my Orbi's setup and my xbox shows "Open nat" until i perform a nat test and it goes straight back to strict/double NAT. I have tried to go
through the ATT's gaming/nat setup and forwarded the same ports as well with the same result. After resetting the Xbox it goes to open but if i perform any tests especially nat test... right back to strict/double. This happens both wireless and wired to
either the Orbi, or the ATT paperweight =-(

To clarify a little on the gateway side as well... As far as i can tell its is bridged but then this ATT has so many settings inside of it who knows. I have shut down the ATT box's wifi bands totally and did the " IP Passthrough" in order to use my Orbi
system as the primary routing setup for the house.

Ok...weird...I ran an ethernet from my orbi satellite to the console and it synced.

However, the word connection showed a strict NAT and that UPnP was not successful. That's an unknown language to me.

Ok...weird...I ran an ethernet from my orbi satellite to the console and it synced.

However, the wired connection showed a strict NAT and that UPnP was not successful. That's an unknown language to me.

Hardwired the Xbox directly to the ATT "gateway" and it still shows strict NAT. I got the ports forwarded through my Orbi's setup and my xbox shows "Open nat" until i perform a nat test and it goes straight back to strict/double NAT. I have tried to go
through the ATT's gaming/nat setup and forwarded the same ports as well with the same result. After resetting the Xbox it goes to open but if i perform any tests especially nat test... right back to strict/double. This happens both wireless and wired to
either the Orbi, or the ATT paperweight =-(

To clarify a little on the gateway side as well... As far as i can tell its is bridged but then this ATT has so many settings inside of it who knows. I have shut down the ATT box's wifi bands totally and did the " IP Passthrough" in order to use my Orbi
system as the primary routing setup for the house.

Could you connect your PC/Mac directly to your AT&T and find out what IP your client get assigned.

On a Windows machine: Bring up the command prompt (cmd) and type "ipconfig" (without quotes).

On a Mac: Bring up terminal window and type "ifconfig" (...).

Post up the first two octets of your IPv4 address. For example, 192.168.xxx.xxx. Remember, only the first two octets.