Color stripe artifacts on the right side on screen at 120hz @ 4k

Looked it up.It's not good

TCL 120hz

But using memc and any advance feature will produce artifacts and if he runs at 4k 120hz it dont matter there is no vvr support on the tv

Those are from multiple review sites not just consoles but blurays etc

Are you sure you wanna run the ps5 or series x without vvr and artifacts @op

Yes I have 4K too. But right now, with my 1440p 120hz settings on. If I start OW2, my screen goes black then “hdr on” pops up. So am I no longer gonna run 120hz?

that monitor supports 120hz and freesync, you don't need hdmi 2.1 for 1080p and 120hz with freesync at all.

you need hdmi 2.1 for 4k at 120hz with vrr.

I have that screen and its fine for most gaming uses.

that screen has console mode for 120hz, and works fine.

1. that screen is not 4K, it is quad and therefore 1440.

2. that screen supports 144hz but does not have 120hz listed as a specific refresh rate in the edid, the console needs edid to list 120hz exact.

OG Pooh has it right. Unfortunately you'll have to just use the generic shapes (the square can be stretched into a rectangle though), and then you can build up the stripes for the car. It might take some time to do, but when you're done you'll be able to
get a stripe design with any colors you'd like. You can therefore go for a color scheme that isn't offered as standard.