Anyone have 3D print files for a cable guard/clip to keep Series S controller wired?

as you have to tilt the cable, then it is either a cable issue or port issue, xbox controllers when used wired are a nightmare for port failure, third party controllers have a moulded design that the cable clips into to stop port stress, shame the xbox version does not.

Hello, Lyingbubble9146 I’m an Xbox ambassador here to assist you. Due to the lack of information. I am going to need you to elaborate.

However, I will list common problems and there solutions. Regarding “Having trouble keeping your Xbox Series S Controller Connected Via charging cable.”

Before we get started, please make sure your Controller is updated.

If your wire/charging cable is having difficulties staying in the charging port and is loose. I recommend changing the charging cable, if that has not solved the problem try changing the charging port or using a different controller. If none of these have solved your problem, visiting this should solve your problem.

If your Xbox Series S Controller is not connecting at or keeps disconnecting Via wire. Try turning off your controller and hard restarting your console. If none of these solutions have solved your problem Contact Microsoft Support.

Xbox series s, wired, or my brand new un used wireless controller that came with the console, it doesn’t matter, and a wired steel series headset. I have not changed the setup in a couple years

Or do the 2014 Way, clone your controller with 3D printer!
www.extremetech.com/.../175233-xbox-one-design-team-used-hundreds-of-3d-printed-prototypes-to-fine-tune-the-console. Be happy that XBOX ONE are cloned! The Day One 2013 gold print could have been done by a Stereolithography plastic etched by Ultraviolet
light!

Hello thanks

I have an Xbox 1 s and a wired headset but my controller is a series s controller. I have tried with a different controller which is an Xbox 1 controller and it fixed the problem. However that isn’t my controller so I still have the same problem.