Zhone: Bridging Guide

Zhone (Modems/Gateways): Bridging Guide
Device Name Zhone 6211-A2-ZB24-10

Login Information:

Default Gateway – 192.168.1.1

Username – admin

Password – admin



Bridging Guide

1. Open a web browser and type http://192.168.1.1 .
   
2. Enter admin for both the Username and Password.
3. Click the Login button found in the lower right corner of the screen.
4. Select Advanced Setup from the menu at the left.
5. Select WAN from the menu on the left.
6. Click the Edit button next to your active connection.
7. Click Next.
8. Select Bridging.
9. Click Next.
10. Click Next.
11. Select Tools from the menu across the top.
12. Select System Commands from the menu at the left.
13. Click the Save All button to make the changes permanent.

:)

 

Zhone: Bridging Guide

With ISP distributel - a factory restore will set bridge mode, PPPOE login info will need to be entered into router to regain web access.

 

Zhone: Bridging Guide

Zhone (Modems/Gateways): Bridging Guide
Zhone 6381-A4

Login Information:

Default Gateway – 192.168.1.1

Username – Admin

Password – Admin



Bridging Guide

1. Open a web browser and type http://192.168.1.1 .
   
2. Enter Admin for both the Username and Password.
3. Click the Login button found in the lower right corner of the screen.
4. From the Home page, click on Setup.
5. Click on New Connection. The default PPPoE connection setup is displayed.
   
6. At the Type field select Bridge and the Bridge connection setup page is displayed.
   
7. Give your Bridge connection a unique name; the name must not have spaces and cannot begin with numbers.
   
8. Set the PVC Sharing to Enable.
9. Enter a VPI and VCI. (Your DSL service provider or your ISP will supply these.)
   
10. Select the encapsulation type (LLC or VC); if you are not sure which to use, use the default mode.
    
11. Select the quality of service (QoS). Leave the default value if you are unsure or the ISP did not provide this information.
    
12. Click Apply.
13. Select Tools from the menu across the top.
14. Select System Commands from the menu at the left.
15. Click the Save All button to make the changes permanent.