Yoke and rudder panel

Hi Longarm,

I had to remap the control keys, and now rudder pedals are ok.

Steps:

Create a new profile for rudder pedals on Controls menù on Pro Flight CESSNA Rudder Pedals section.

Brakes

Left/right brake - Joystick L-Axis X /Joystick L-Axis Y

Flight Control Surfaces - Primary Control Surfaces

Rudder Axis - Left/Right - Joystick R-Axis Z

Now I missed switch panel / Radio Panel / Instrument panel, but I'm working on that.

Thanks anyway.

This an observation on a PC based version of FS 2020. My Thrustmaster Warthog HOTAS stick and throttle and T-Rudder pedals are supported and work fine. The Saitek Multi Panel, Switch Panel, Radio Panel, Throttle Quadrant, and FIP's do not work in FS2020.
I did get the Prop and Mixture to work correctly on the attached Throttle of the Yoke, but the additional Throttle Quadrant is a no go. All of these pieces are working perfectly in FSX on this same machine, so it is FS 2020 that is the problem. I dug out an
old USB 2040 digital switch. FS 2020 saw that just fine. I hooked up my old "Park Brake" Switch and mapped it in the controls set. It works fine. If they can see old technology like that piece, I wonder how hard it would be to write drivers for the above mentioned
pieces. The 64 bit Windows 10 Saitek drivers work perfectly in FSX on the same machine.

Good luck setting up controls if you have good ones. I'm a real world pilot and have Cirrus Yoke, MFG Crosswind rudder pedals, and GoFlight Console panel and GoFlight autopilot. I have worked on and off for weeks now trying to get any of these to work and
have even gotten the GoFlight Interface Tool and tried that, and the beta Fsupic7 to set up controls. Shouldn't have to go thru all this just to get a flight simulator to recognize your controls. I started back in the 80's with the first MS flight simulators
and presently fly on Prepar3d. So, every once and a while when I feel like trying again I try and set the controls up so I can fly.

Paul

PS... just checked the rudder function on the Airbus CH joystick and the rudder function reacts the same. With full deflection rudder deflects fully, but then returns to center even though commanded to full deflection.

Hi, if you have T-Rudder pedals then in settings 'rudder axis' choose 'Joystick L-Axis Z'.

I hope this help