Xbox One X controller keeps turning off when LB button is pressed twice

The graphic could be turned off. It's a simple one button press to turn it off.

Load up your tunes and press the LB and RB buttons and see if it changes.

Power down, press and hold the sync button (the small one to link in wireless controllers) and while holding it press the power button.

Continue to hold the sync button until the console is booted up.

Go to System Settings and choose storage.

On your controller, press the following button sequence: LB-RB-X-LB-RB-X where LB is the Left Bumper and RB is the Right Bumper

Now, retry updating from the USB drive.

Power down, press and hold the sync button (the small one to link in wireless controllers) and while holding it press the power button. Continue to hold the sync button until the console is booted up. Go to System Settings and
choose Storage. On your controller, press the following button sequence: LB-RB-X-LB-RB-X which will cause a reboot and the update will then prompt you once more.

There are no left or right buttons on the controller, bit of a pain to navigate the menus when you're asked to press LB or RB. The only fix it to turn the wheel off and use a controller to do the LB/RB and then switch back to the wheel. I don't see where
they could have put the buttons to be honest but it is a little annoying not having them.

When turning you can/should use the bumper buttons LB/RB to "correct" the plane when doing a sharp turn or in "knife filght" for example.. when executing a right turn you press LB to keep the plane from desending/crashing.