Xbox One with Optoma HD141X Projector

I replaced a BenQ projector with a Optoma HD141X and Xbox one will turn it off but not on. I tried all of the codes listed in the Xbox One for Optoma devices and several would turn it off but not on. I can find codes for all of my other devices that work
except the Optoma HD141X. Does Xbox One have a way for it to learn codes or use the link command over HDMI to control devices?

:)

 

Turning off TV/Projector Optoma HD20

Please let me know how you configured your xbox one to turn on your projector. I have the optoma 8200

 

Help connecting my XBox to my projector - Should be working

I have BOTH an optoma HD600X-LV (720P) and just got a Optoma HD131XE (1080P). after about 2 years on my 42" LG tv my xbox 360 Slim would no longer connect by HDMI, however it did connect to my new 720p Optoma projector fine so i wasn't that bothered. However
i have just upgraded to a Optoma 1080p projector and my xbox 360 will not connect the projector pauses on HDMI 1 the screen goes black for 10 seconds and then it cycles through the other inputs. My xbox one however will work on both and the 360 does play thought
the 1080p but only when played through the xbox one with lag.

Any ideas on a box such as DVD player etc that has hdmi in and out that i can use to re-route the signal same as the xbox one without lag?

 

Let me know if you figure that out. I am planning to buy the same projector.

Unrelated question, I assume you've connected Xbox via HDMI, have you tried to connect wirelessly somehow? I am trying to figure out if that's even possible.

 

Did you ever find an answer to this? I have th e same projector and the same issue. Thanks.

 

I'm also having this problem. My old projector used to do something similar, and they eventually fixed it.

 

The problem is, the XBOX is toggling the 'off' command instead of using the separate 'on' command. If you turn the projector on and then power up the XBOX, you will see the projector display the 'press again to confirm off' pop up box, because it has received
a single 'off' command from the XBOX. MS need to update the profile with the separate 'on' command as this projector doesn't use the same IR signal to power on and off.

 

+1. I reported this via twitter but i don't think its on their radar.

 

Saw this thread when I was looking for information on getting my HD141X to work with the Kinect.

Did some digging and found a remote code for the GT1080 (another Optima projector that the remote control for the HD141X can control)! Both on and off commands work flawlessly.

The code is as follows:

T4072

 

Thank you patel4prez!!

I can confirm T4072 works for optoma HD141x

 

Yes patel4prez is right. It works for my HD141X!

 

Thank you! I can confirm that T4072 also solves this problem for the Optoma UHD60 (and probably the UHD65 too).