Xbox One PSU fan always at 100%.

DanielPhi11ips · Feb 11, 2016

Hi,

The PSU for my Xbox stay at 100%, and is as noisey as the console it's self. When put in I wtant on mode, the fan is always at 100%, is this normal behaviour?

Thanks,

Dan

:)

AlexO'brien · Feb 11, 2016

instant-on mode

Hi is having my xbox one in instant on mode bad does it wear out the console or the psu like when its on instant on mode the fan in the psu is always spinning is this bad thank you .

Fuhgeddit · Feb 11, 2016

Can I use an Xbox 360 slim power brick on an Xbox One

Not unless you want a broken brand new xbox one, The xbox 360 power brick is totally different from the xbox one power brick and Im pretty sure they both have different voltage and different amperage out put? ah Hell here's some info from xbox.com I looked up for you below about the whole thing....

About your Xbox 360 console’s power supply unit and cord
Your Xbox 360 console has an external fan-assisted power supply unit (PSU). The PSU has the same basic design in all countries. The maximum dimensions of the PSU are as follows:

The 220-240V power supply measures 8.62 x 3.03 x 2.13 inches (approximately 21.9 x 7.7 x 5.4 cm).

The 110-127V power supply measures 8.42 x 3.03 x 2.13 inches (approximately 21.4 x 7.7 x 5.4 cm).

Some PSUs are shorter but have the same capabilities. For example, the PSU is slightly smaller in countries that use 110-volt electricity.

Xbox 360 E Console: The Xbox 360 E console uses a 120-watt PSU.

Xbox 360 S console: The Xbox 360 S console uses a 135-watt PSU.

Xbox 360 original console: There are several versions of the PSU for the original Xbox 360 console. Depending on the power requirements of the console, a 203-watt PSU, a 175-watt PSU, or a 150-watt PSU may have been included.

XBOX ONE Power supply unit and cord
Your Xbox One console has an external fan-assisted power supply unit (PSU). It measures 6.69 x 1.88 x 2.96 inches (approximately 17 x 4.8 x 7.5 cm). Note that the PSU has the same basic design in all countries. There are no dimensional changes between the 100-110V, 220-240V, and 100-240V versions.

Important Microsoft does not license any non-Microsoft accessories that plug into the Xbox One console's power socket. The use of any accessory other than the standard Xbox One PSU may damage your console and void your console warranty.

Notes

PSUs are designed to be used only in the regions where they are sold.

Don't try to use an Xbox One PSU that was built for a region that has different power requirements.

Don't use an unlicensed accessory, such as a non-Microsoft replacement PSU, or any accessory that plugs in between the console and the PSU.

Don't use the Xbox One external PSU outside the country where it was sold. If you use the PSU in a different country, it or your console may be damaged, and the warranty may be invalidated.

The Xbox One PSU contains an internal fuse that helps protect your console from voltages that are too high and power surges. However, the PSU is a sealed unit. Therefore, you can’t replace the internal fuse.

Power cords

DC power cord

The PSU has a hard-wired, direct-current (DC) power cord that connects the PSU to the console.

The DC power cord is approximately 3 feet, 6 inches (1.1 meters) long.

A proprietary power connector is permanently attached to the end of the DC power cord. This connector is designed specifically for the Xbox One console power socket.

AC power cord

The AC power cord connects the PSU to the wall socket. The AC power cord is detachable from the PSU.

The AC power cord is approximately 5 feet, 9 inches (1.2 meters) long.

The end of the power cord that plugs into the PSU has two holes. If you use a power cord other than the one designed for your PSU, you may damage it or your console.

The plug at the end of the power cord that connects to your electrical outlet can be one of several types. The plug type depends on the country and region where you purchased your console.

Power supply placement, temperature, and noise
To provide sufficient cooling, the Xbox One external power supply uses a built-in fan to blow air through the PSU.

Notes

The PSU fan automatically starts when you press the power button to start your console.

Typically, the fan makes a "whirring" noise.

When your console is in energy-saving mode, or when it’s disconnected from the PSU, the fan doesn’t operate.

If your console is in Instant-On power mode, the PSU is still on and the fan will spin.

The speed of the fan increases or decreases when the temperature of the PSU changes. If the fan speed changes, the whirring noise that the fan produces increases or decreases.

To help the power supply operate efficiently and safely, follow these precautions:

Don't block any ventilation openings on the PSU.

Don't put the PSU on a bed, a sofa, or any other soft surface that might block the ventilation openings.

Don't put the PSU in a confined space, such as a bookcase, a rack, or a stereo cabinet, unless that space is well-ventilated.

Don't put the PSU near any heat source, such as a radiator, a heat register, a stove, or an amplifier.

Don't stack other electronic devices on top of the PSU.

Make sure that the PSU is positioned horizontally and lays flat on the four rubber pads on its base.

Click to expand...
Click to expand...

holy manual

{Parity} · Feb 12, 2016

It is not normal for it to run at 100% all the time. Make sure that the vents on the PSU are free from dust/dirt. It may not be well ventilated.

If necessary you may need to get it replaced
http://support.xbox.com/

DanielPhi11ips · Oct 31, 2018

Yeah it has adequate ventilation, it has also tripped the fuse box in my house once. I guess it might need replacing then.

DanielPhi11ips

Yeah it has adequate ventilation, it has also tripped the fuse box in my house once. I guess it might need replacing then.

{Parity}

It is not normal for it to run at 100% all the time. Make sure that the vents on the PSU are free from dust/dirt. It may not be well ventilated.

If necessary you may need to get it replaced
http://support.xbox.com/

Njal the Blue

Sorry but the information in the link is wrong.

Power supply and cord

Xbox One S and original Xbox One come with an external fan-assisted power supply that measures 6.69 x 1.88 x 2.96 inches (about 17 x 4.8 x 7.5 cm). The size is the same in the 100-110V, 220-240V,
and 100-240V versions.

Both the Xbox One S and Xbox one X have multi voltage Internal PSUs only the Original Xbox one has an external PSU.

PixelPatch

It may be the fan in the PSU making the noise. I know mine is always making a rather faint noise of a fan when in this mode.

Notes

Your console may sound as if it’s on when downloading and installing updates.

In Instant-On power mode, the console power supply unit (PSU) remains on and the solid white LED on the PSU is bright. You may also hear the fan in the PSU.

The console uses 15 watts of power when in Instant-On mode.

Martin Doyle

Power supply unit and cord

Your Xbox One console has an external fan-assisted power supply unit (PSU). It measures 6.69 x 1.88 x 2.96 inches (approximately 17 x 4.8 x 7.5 cm). Note that the PSU has the same basic design in all countries. There are no dimensional changes between the
100-110V, 220-240V and 100-240V versions.

Important Microsoft does not license any non-Microsoft accessories that plug into the Xbox One console's power socket. The use of any accessory other than the standard Xbox One PSU may damage your console and void your console warranty.

<p>

Notes

*PSUs are designed to be used only in the regions where they are sold.

*Don't try to use an Xbox One PSU that was built for a region that has different power requirements.

*Don't use an unlicensed accessory, such as a non-Microsoft replacement PSU, or any accessory that plugs in *between the console and the PSU.

*Don't use the Xbox One external PSU outside the country where it was sold. If you use the PSU in a different country, it or your console may be damaged, and the warranty may be invalidated.

*The Xbox One PSU contains an internal fuse that helps protect your console from voltages that are too high and power surges. However, the PSU is a sealed unit. Therefore, you can’t replace the internal fuse.

More Info:
support.xbox.com/.../about-power-supply

Xbox One PSU fan always at 100%.