xbox one. Console by clicking on the logo - run, in a second beeps and off.

Hi there,

May be worth trying the following steps to reset the xbox s video settings.

1. If there's a disc in the Xbox One console, eject it.
2. On the console, press and hold the Xbox button for five seconds to turn off the console.
3. Press and hold the Xbox button and the Eject button until you hear a beep to turn on the console. You will hear one beep right away and a second beep 10 seconds later. The power light will flash on before the second beep.
   DO NOT LET GO until the second beep occurs.

Unlukily when i press the power button the console beep but the white logo doesent apper, same thing happen when i press the eject button, the beep for that button play but notthing else.

Another thing might is important, when i press a button that make a beep the power brick turn on for an half second end then turn off.

Try this to see if it helps with your controlling loser sync.

Eject any disks in the console.

Hold down the Xbox logo on the front of the console for 5 to 6 seconds until it beeps and turns off.

After it is powered off, unplug the power from the back of the console itself. Wait 10-20 seconds. Plug the console back in and power it back up.

Re-sync your controller and continue playing.

I see. Could you try resetting your console's display settings? like this:

"Display reset"

• If there's a disc in your console, eject it.

• On the console, press and hold the Xbox button for 10 seconds to turn off the console.

• Press and hold the Xbox button and the Eject button until you hear a beep to turn on the console.

You’ll hear one beep right away and a second beep 10 seconds later. The power light will flash on before the second beep. DO NOT LET GO until the second beep occurs.

*Note: If you have an Xbox One S All-Digital Edition, you’ll need to press and hold the Xbox button and the Bind button instead, as your console does not have an Eject button.

One thing you could try is putting the console into low res mode and see if it happens then. You can do this by doing the following, starting with the console powered fully off.

Press and hold the Power button and the pair button until you hear a beep to turn on the console. You'll hear one beep right away and a second beep 10 seconds later. The power light will flash on before the second beep. Don’t let go until you hear the second beep or see the console start-up in low resolution mode (the Xbox start-up screen will appear slightly pixelated).