X Box will connect to tv but says no signal

Hi, Ray. My name is Ron, I'm an independent advisor. I will be more than happy to help you.

Please try the following steps one at a time to resolve the issue:

Confirm that both your TV and Xbox One console are turned on.

Check that your TV is set to the correct input signal (HDMI).

Check that the HDMI cable connections to your console and to your TV are secure.

Check that the HDMI cable is connected to the "out to TV" port on the console.

Try plugging the HDMI cable into a different HDMI port on your TV.

Try using a different HDMI cable to connect your console to your TV.

Try connecting your console to a different TV.

Power cycle your Xbox One: Press and hold the Xbox button  for 10 seconds to turn off the console, and then turn it on again.

Hello there @junaidaamir, I hope everything is going well!

Thank you for reaching Microsoft Xbox Forum support. I am sorry to know about the console situation; However, I believe your console might need just a system refresh to perform the system update successfully. I would like you to go through the following steps to perform a quick power cycle.

I invite you to perform a quick power cycle by turning off the console and then unplugging all the cables. After 2 to 3 minutes, re-plug them back again, then restart your console.

If you are still getting the same issue, I would like you please to kindly follow the instructions below to physically reset your console:

- Turn off the console unplug all the cables then re-plug them back again.

- Since the console is an all digital one, click on the "Bind" button, after 10 seconds click the home "X" button just once without letting go of the button. Throughout the whole process you will hear two beep sounds and end up with a troubleshooting page. On your screen. You will need to select the "Reset this Xbox" option and choose "Reset and keep my games and apps".

Note =>The "Reset and Keep my Games and Apps" option will not cause losing your games, but please be aware that you need to be completely aware of the email address as well as the password of your account before going for it because it will require you to sign in to the account.

In case all previously mentioned troubleshooting steps weren't helpful, the next solution would be to perform an offline system update. In the link below you will be directed to everything you need to know about the offline update and how to run it.

The link: Perform an offline system update | Xbox Support

I wish you a lovely day, and I hope this helps you out! All the best!

Kind Regards

Stay safe, and happy gaming!

After one day of having the xbox one hooked up to get the cable box hdmi signal from my Yamaha RX-V665 receiver, the cable box seemed to be overheating (presumably from Xbox pulling video constantly / polling the tv guide). The issues seen are the xbox displays
"We lost your TV signal, make sure your cable or satellite box is on and plugged in to the xbox" randomly while watching TV, at which time the display on the cable box shows "DUI (download user interface) as if it has just been restarted. Tested using through
receiver and directly connected to cable box with the same results, TV freezes and signal is lost often within moments randomly. Immediately after having the issue I can hook the cable box up directly to the TV at which time the TV signal works flawlessly.
Therefore the issue has to do with how the xbox one is utilizing the HDMI signal to and from the cable box. The cable box has never exhibited these issues before and doesn't have them when not connected to the xbox.

I have gone thru the tv setup, and it detects the tv and cable box no problem.

I have also tried leaving the directv box on and turning the xbox off and when i turn it back on it again says it lost connection.

As soon as i press the off button on the directv and then back on, the xbox gets the signal.

Anything else?

When you say 4K pass through, are you talking about a 4K source sending the TV signal to the Xbox and then to the TV? Or sending the Xbox1 X 4K signal to pass through a 4K receiver and then to the 4K TV?