Where is the “enable” button? It says to “press “enable” on your console to get connected”...

The procedure is the same for connecting the control on the console: enable the Bluetooth of the phone and press the button on the front of the control.

Hi

You will need to go into the settings for your television and enable Deep Colour for the HDMI port you have connected your console to for HDR to work.

On my B6 TV I press and hold the settings button on the controller to bring up the menu then select General and scroll down the list to where it says HDMI ULTRA HD Deep Colour and select on against the HDMI port your console is connected to.

Can you verify what Hakko Tenshi asked, if this is a DSL connection?

Before configure any static set-up, can you make sure UPnP (Universal Plug and Play) is enabled on your router. If disabled, tick enable, save/apply and reboot your router.

You may also try to rollback to a previous portion of the system update. To do so!

Turn off your console. Press and hold the sync button (the small one you use to connect your wireless controllers). While holding press the power button to turn your console on. Continue to hold the sync button until the console is booted up.

Go to System Settings and choose storage.

On your controller, press the following button sequence:

Press the left bumper.

Press the right bumper.

Press the X button.

Press the left bumper.

Press the right bumper.

Press the X button.

Post back and let us know how it goes.

Sorry for the interruption!

When you say, "poor connection", is this exclusively related to latency, or do you experience intermittent disconnections as well?

If you haven't already, reset the TG582n to factory settings.

If you use PPPoE/A for connectivity, make sure you take note of the username and password, for the authentication process.

Normally when you do a hardware reset, there should be a reset button, often located on the back, or on the side, of a modem/router. Press and hold the reset button for 10 seconds. Power off your gateway for 2 minutes. Power on and wait one minute for it
to connect properly.

Although UPnP (Universal Plug and Play) is enabled by default, for the majority of routers, make sure this feature is ticked enable.

On your console, delete a portion of the system update, installed on your console, and reinstall the update. To do so:

Go to System Settings and select storage.

On your controller, press the following button sequence:

Press the left bumper.

Press the right bumper.

Press the X button.

Press the left bumper.

Press the right bumper.

Press the X button.

Post back and let us know how that goes.

They will continue if the console has Background Downloads enabled.

Press the Guide button your controller. Go the the Settings blade and pick System Settings.

Now pick Startup and Shutdown, then go to Background Downloads.

Here simply Enable them.

Now when you press the off button or the 360 goes to turn itself off, the console will go into a low power mode until the download is complete.