When powering Xbox Series X on using a controller, sometimes my Xbox power button jumps...

Hi SamL7! My name is Ricardo an independent advisor ready to help you with this situation!

If this is not what happens all the time and you can play games normally, could be that you haven't turned the TV or energy issues

You should try on a different power outlet and have the tv on and on the proper HDMI chanel

Hello ÚÑKÑØẄÑ ©, My name is David. I am an independent advisor, happy to help you today.

I'm sorry you're experiencing this issue with your Xbox Series X controller. Here are some possible solutions you could try:

Restart your Xbox console: Press and hold the power button on your Xbox console until it turns off. Next, disconnect the Xbox Series X from its power source. Turn off the Xbox controller and remove its batteries. Finally, connect and turn on your Xbox Series X.

Restart the controller: Press and hold the power button on the controller for several seconds until it turns off. Then turn it back on.

Pair the controller with the console again: Press and hold the sync button on the console until the power button flashes. Then, press and hold the sync button on the controller until the lights on the controller flash.

Best regards.

Hello,

Its not xbox serie shut down sometimes.

It's the contrary, sometimes when i try to launch it with the controller, the xbox does not power on. Then i push the button in front of the xbox but nothing is shown on TV and controller not respond.

I have to push button again to shut down and power up again.

I thought fix it with a clear cache, but it happened again today.

Regards

hello fellow gamers this can also be caused if you leave a USB device plugged in that draws power from your Xbox the Xbox One and the Xbox 360 did the same thang years ago, we used to have one of those old USB charging docs that plugged into your Xbox 360 and every time we were done using it my dad would unplug it because it would annoy him to sit and watch the power light on the Xbox Paulse off and on

the series X does the same thang the only reason know this is because I prefer to use afterglow corded controller's and I have an Xbox series X and every time I don't unplug my controller when I'm done with my Xbox and power it down the power light on my series X Paulse's forever. LOL

Hi, power the xbox and your controller on then press and hold the power button on the xbox for ten seconds, when the xbox powers off pull the power cord out of the xbox, wait two minutes, reconnect the power cord and power the xbox on using the power button
on the xbox.

Resync the controller and then try using the controller to power off/on the xbox.