Teredo

Hi MORIFUY,

Probably Teredo Adapter is disabled, pelase run this command to see if it is disabled.

netsh interface Teredo show state

To re-enable the Teredo adapter:

Right-click the Start icon, and then select Command Prompt (Admin).

Run the following command from the Admin command prompt:

netsh interface Teredo set state type=default

Note The Microsoft Teredo Tunneling Adapter will reinstall automatically. Don’t install the Teredo Tunneling Pseudo-Interface adapter manually in Device Manager, as this may cause issues with Teredo functionality.

Best Regards,

Angel.

Hi,

Run CMD as an Administrator and Try these commands.

netsh int teredo set state disable

netsh int teredo set state type=default

netsh int teredo set state enterpriseclient

netsh int teredo set state servername=teredo.remlab.net

Teredo is a networking protocol that’s used to establish secure communications between clients and servers, and to facilitate connectivity between devices behind routers that use network address translation (NAT).
Failure to obtain a Teredo IP address can occur when there’s an issue with your Teredo adapter, when a device on your network is blocking the Teredo protocol, or if there’s software installed on your PC that’s disabling Teredo functionality. Without a Teredo IP address, you’ll be unable to use party chat or do multiplayer gaming on Xbox Live

Open an Admin command prompt. In the command prompt type netsh interface Teredo set state disable.

Open up Device Manager. Go to View, then select Show Hidden Devices. Delete any network adapters with ‘Teredo’ in the name. You may have two showing, one named ‘Teredo Tunneling Pseudo-interface’ and one named ‘Microsoft Teredo Tunneling Adapter’.

Reboot the PC.

Re-enable Teredo by running the following command in an Admin command prompt: netsh interface Teredo set state >type=default.



Reboot the PC.

我是在网络适配器里没有任何关于teredo的东西，并不是teredo被禁用

[Translation - I am not having anything about teredo in the network adapter, not teredo is disabled.]