Remote control code settings missing

Figured it out. the. There is a typo on the code that gets auto generated.. it should be r1189 vs r0189. Found the codes t the link below

www.docstoc.com/.../HD-PVR---Remote-Control---Code-list-for-direct-set-of-TVs-DVDs

Echomalleus, some of the Dish Network boxes support multiple remote control code sets (in case you want to have two boxes in the same room, for example). If your box supports that, can you check in the settings menu on your receiver to see if yours is set
to remote control #1 or primary? That is the code set the Xbox usually defaults to using...

I had to manually change the remote control code in the settings, guide one, trouble shooting, and mine now works.

OK, I am battling a similar problem. First, I have gotten Xbox One to control my Genie HR44 successfully. What I did was switch it from RF to IR mode and set it up to work with an older RC65 or RC66 remote (from another DVR box HR22). I can control the HR44
with this (RC66) remote selector set to "D" (DirecTV). So with that done, I was able to march through the Xbox TV setup telling it that my Sat provider was DirecTV and then let it run through the automatic equipment identification (sending Channel UP). Once
that was done, I could control the HR44 with my voice. It understands channel selection, Pause, Play, Skip, etc.

Now here is my problem. I also have an older DVR box (HR22), and using the RC66 remote in the "D" mode controls both the HR44 and HR22 at the same time. Not what I want. I can setup the HR44 to use different codes by changing its Remote Control receiver
mode from DirecTV to AV1/AV2 (under Menu-Settings&Help-Settings-Remote Control-Receiver Mode). Once done, I can control the HR44 with the RC66 selector set to AV1 and I can control the HR22 with the RC66 set to "D".

My problem is that I cannot get the Xbox One to send these alternative codes to control the HR44 when it's in this AV1/AV2 mode.

I did notice that under the Xbox One Troubleshooting menu there is an option to to enter a specific device remote control code (Menu button - Settings- Troubleshooting-Enter Device Remote Code). It is looking for some unspecified 4 digit code. There is not
mention of what kind of code, brand, etc. There is a reference to support.xbox.com but I could find no mention of this there. A thorough search of the Internet didn't reveal anything either. I did find some 4 digit codes for various universal remote controls
from brands like RCA and Panasonic but I'm not sure if these are what the Xbox One is looking for.

Any help here would be appreciated. There must be a code to get the Xbox to send the Alternative (AV1/AV2) codes for a DirecTV box. I'm surprised that Microsoft doesn't have an article on the use of these 4 digit codes...

Thanks,

Scott

A support person from dish tried to tell me the Joey's don't have IR, but I can use my Logitech universal remote on it. Regardless I pushed on how to change the IR setting on the Joey and got this. Take this with a grain of salt. "Okay. I double checked
in the settings. The Joey will only respond to bluetooth controls. There isn't even a way to program the remote to the receiver manually. There is a wizard that walks you through saving a presaved code into the remote but those are codes that control 3rd party
devices. There isn't a way to program an IR controller to control the Joey or the Hopper. I'm sorry but if it is possible, it is not designed to be done that way."