Netgear Netgear DGN3500: Firmware Update

Discus and support Netgear Netgear DGN3500: Firmware Update in XboX Networking Hardware to solve the problem; Netgear (Modems/Gateways) Netgear DGN3500: Firmware Update Login Information Gateway - 192.168.0.1 Username - admin Password - password Firmware... Discussion in 'XboX Networking Hardware' started by XB1R Hades, Jul 25, 2014.

  1. XB1R Hades
    XB1R Hades Guest

    Netgear Netgear DGN3500: Firmware Update


    Netgear (Modems/Gateways) Netgear DGN3500: Firmware Update
    Login Information

    • Gateway - 192.168.0.1
    • Username - admin
    • Password - password
    Firmware Update

    Auto Update

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Open web browser.
    3. Login to router by entering http://routerlogin.net in to the address bar or by entering the default gateway IP address.
    4. The router will then prompt you to enter the user name and password. the default user name and password are: "admin", "password".
    5. The netgear smart wizard will automatically search for updates upon login, if an update is available click install.
    Manual Update

    1. Plug the computer into a LAN port via an ethernet cable.
    2. Open web browser.
    3. Login to router by entering http://routerlogin.net in to the address bar or by entering the default gateway IP address.
    4. The router will then prompt you to enter the user name and password. the default user name and password are: "admin", "password".
    5. Select Advanced from the tabs at the top.
    6. Select Administration from the menu on the left.
    7. Select Router Update from the submenu.
    8. In an alternate web browser or tab go to www.NETGEAR.com and download the updated software. If not done automatically uncompress the file.
    9. Click Browse.
    10. Locate and select the file you just downloaded and uncompressed.
    11. Click Upload to send the software to the router. This loads the new software in the router and causes the router to restart. Note: Do not try to go online, turn off the router, shutdown the computer or do anything else to the router until the router finishes
      restarting! When the Ready light stops blinking, wait a few more seconds before doing anything.
    12. Click Router Status and check the Firmware Version to verify that your router now has the new software installed

    :)
     
    XB1R Hades, Jul 25, 2014
    #1
  2. COCOLINHO
    COCOLINHO Guest
    Netgear Netgear DGN3500: IPv6

    Netgear (Modems/Gateways) Netgear DGN3500: IPv6
    Does my router supports IPv6.
     
    COCOLINHO, Jul 25, 2014
    #2
  3. XB1R Athena
    XB1R Athena Guest
    Netgear Netgear DGN3500: Device Manual

    Netgear (Modems/Gateways) Netgear DGN3500: Device Manual
    Device Manual

    Click
    here     to go to a manual for this device
     
    XB1R Athena, Jul 25, 2014
    #3
    Error:Failed to connect to localhost port 9200: Connection refused
Thema:

Netgear Netgear DGN3500: Firmware Update