nat type not turning open even after port forward

Zeus Swerve Boi · May 16, 2021

so i made the ipv6 from secured to open,upnp has been on,i port forwarded all 7 ports,under lan setup i put Address Reservation for the series x ip. and it is still no IPV6,no UPNP,nat moderate.

and also this series x always had ipv6,upnp successfull,nat open. only two days ago these issues started happening. then i went ahead and made the changes.

:)

XBF Zineb F

When the Nat type is showing any status except "Open", there are some specific ports that need to be opened from your internet service provider's end. You might want to give them a call, and request to have all the following ports open:

Port 88 (UDP) Port 3074 (UDP and TCP) Port 53 (UDP and TCP) Port 80 (TCP) Port 500 (UDP) Port 3544 (UDP) Port 4500 (UDP).

Zeus Swerve Boi

What about the IPV6 issue?

Zeus Swerve Boi

Please reread my post. I already stated that i did the port forwarding for all 7 ports

Jamie1993

It can help with the NAT type not being open

Zeus Swerve Boi

Is this for the IPV6 issue?

nat type not turning open even after port forward