My Xbox series s power button just blinks 3 times over and over

Okay I'm going to give it a shot

Hi, I hope you're doing great out there. I am an Independent advisor and I am here to help you in regard to your concern.

Kindly perform a powercycle on your console by following the steps below:

​​​

POWERCYCLE CONSOLE​​​

​​​

1. Turn off your console by holding the Xbox button on the front of the console for approximately 10 seconds. The console will turn off. ​​​

2. Unplug your console for 5 minutes.

2. Turn your console back on by pressing the Xbox button on the console or the Xbox button on your controller. ​​​

If that didn't work, In this case, we just need to reset your console keeping your games and apps through the Xbox Troubleshooter page. Don't worry because as long as you're connected to Xbox Live your saved progress, games, will not be deleted. It will remove all of your accounts but you can add all of them later on.

Make sure to follow the steps accordingly to access it:

1. Unplug the network cable if you're using a wired network connection.

2. Power off your console, and then unplug the power cord to ensure that the console is completely powered off.

3. Wait 30 seconds, and then plug the power cord back in.

4. Press and hold the Pair button and the Eject button, and then press the Xbox button on the console.

5. Continue holding the Pair and Eject buttons for 10-15 seconds.

6. Listen for two “power-up” tones a couple of seconds apart. You can release the Pair and Eject buttons after the second power-up tone.

When the console powers up, you will see the Xbox Startup Troubleshooter. Please click on "Reset this Xbox" then "Reset and keep my games and apps".

I purchased a new power supply and still had same issue. I was finally able to get the xbox one power on by unplugging the power supply from the xbox and then reconnect the power cord and while the power supply light is blinking I had to keep moving my finger
over the power button like I was strumming a guitar. I had to power cycle the xbox about 4 times while doing this but on the last one the power button turned white and I haven't powered it off since.

i'm just a bit confused because i've looked all over youtube and google but i couldn't find anyone else that had the same issues. because when they press the sync button on their controller it starts blinking but my controller doesn't do anything at all, it's like just that one button stopped working and all it does is do the slow blinking the controller does after you power it on.

This might be your issue:
support.xbox.com/.../power-button-blinks-red

If that isn't your problem, can you provide more information. Make sure you look all over Xbox.com to find solutions, many you can find, and fix on your own.