Joystick glitch

Try performing a hard reset EXACTLY like this. Hold the power button on the console for 8 seconds or until the power shuts down completely. Unplug the power cord from the back of the console for 5 minutes. Plug the power cord back in and restart the console.

If that doesn't help you may need to see if the joystick needs to be repaired/replaced.

So controller #1 has a walking glitch, but when i let go, i doesn't "slide" after i release the joystick. Controller #2 has no walking glitch BUT i slides a little bit after i let go. Any tips?

Just to clarify a little bit. Do this glitch as you would normally do. Look up at the ceiling, do the jump animation, after the jump animation do not touch the left joystick, using the right joystick turn around and look at door, push backwards on left joystick.
If you did this correctly you will noticed that your cross hairs have shifted upwards sightly from where you were aiming on the door. Once this happens just hit the jump button.

The analog joystick... Cursor going in any direction it wants to ... Without touching the joystick... You can calibrate your joysticks... Or re-center them... There is a setting somewhere in the 360... Calibrate analog joysticks or calibration settings for
joystick... Calibrate your joystick... I have seen it before but cannot locate now

But it resets or recenters/realigns your joysticks so it doesnt drift all over your page... Your cursor

Hello PepeMz, My name is David. I am an independent advisor, happy to help you today.

These glitches can be a little frustrating

First connect the controller to your Xbox console or PC and check if firmware updates are available. If an update is available, follow the instructions to update the controller firmware. Firmware updates can fix compatibility issues and improve controller performance.

Then clean the joystick Sometimes the buildup of dirt, dust, or debris can affect the performance of the joystick. Use compressed air or a cotton swab lightly moistened with ********* alcohol to gently clean around the joystick and remove any dirt or debris that may be present.

Finally, calibrate the controller, try calibrating the controller in Xbox settings. Go to Settings > Devices and accessories > Your controller > Configure > Calibrate. Follow the on-screen instructions to calibrate the controller joysticks.
Calibration can help correct problems with incorrect response or lack of registration.

Best regards.