If I factory reset by holding pair and power button to try to fix usb hdd recognition. Will...

Hi there! This is Virginia O.

I understand that you want to know what happens when you reset your Xbox to factory default.

I apologize for the inconvenienced this has caused you. I will do my best to help you.

When you factory reset your Xbox you will get 2 options to choose from and these are:

1. Reset and Remove Everything wherein it wipes all data completely, like doing a full factory reset.

2. Reset and Keep My Games & Apps. This removes accounts and settings but retains installed games and apps to avoid having to redownload them. Therefore, you do not need to reinstall your games when you choose this option.

Thank you for your cooperation.

Try resetting the controller, follow the below steps

Hard Reset:
A hard reset is more thorough and can help if your controller is not responding as expected.

Turn off your Xbox console.
If the controller is connected wirelessly, press and hold the Xbox button on the controller for about 10 seconds. The controller will power off.
If the controller is connected via USB, unplug the USB cable.
If your controller has a removable battery pack, take out the batteries.
Wait for a few seconds to ensure any residual power is drained.
Reinsert the batteries or plug in the USB cable.
Turn on your Xbox console.
Press the Xbox button on the controller to turn it on. The controller should resync with the console.
Factory Reset (Advanced):
A factory reset of a controller is rarely necessary and should be used as a last resort. This will erase all pairing and customization settings from the controller.

Turn off your Xbox console.
If the controller is connected wirelessly, press and hold the Sync button on the controller (located next to the USB port).
While holding the Sync button, press and hold the Xbox button on the controller.
Continue holding both buttons for about 10 seconds.
Release both buttons.
Turn on your Xbox console.
Press the Xbox button on the controller to turn it on. The controller will be reset to its factory settings and will need to be paired with the console again

You can try to factory reset your console without using the USB flash drive:

- Power off your console, and then unplug the power cord to ensure that the console is completely powered off. Wait 30 seconds, and then plug the power cord back in.

- Press and hold the Pair button (located on the left side of the console) and the Eject button (located on the front of the console), and then press the Xbox button on the console (the Xbox Series S and the Xbox One S All-Digital Edition do not have Eject buttons. Just hold only the Pair button nd then pressing the Xbox button).

- Continue holding the Pair and Eject buttons for 10-15 seconds. Listen for two “power-up” tones a couple of seconds apart. You can release the Pair and Eject buttons after the second power-up tone.

- The console should power up and take you directly to the Xbox Startup Troubleshooter. Select "Reset this Xbox" > Reset and keep games and apps.

See if this helps. If the issue persists, you would need to take the offline system update route.

If a hard reset (holding the power button on the console for 10 seconds) doesn't improve the situation, turn the console off again by holding the power button for 10 seconds.

Now hold Eject and Bind buttons and turn the console on. Keep holding down the Eject and Bind buttons, until the console boots to a recovery menu.

Try doing a factory reset keeping your games and apps.

After doing the factory reset, and the console still not working properly, try doing a

factory reset via USB drive as described here.

HI.

Have you tried resetting your headset and then pairing them again?

To power off and reset headset (hard reset)

- pressure and hold the mute button for 15 seconds

- you may hear a sound and the headset should turn off

- then connect the transmitters USB power cable

- power up the headset

Then attempt to pair the headset again

I believe because it's currently paired to the phone it has to be reset to pair to the console

Hope this helps