I BROKE MY XBOX AND I NEED HELP RIGHT NOW!!

same here

do you have anyway of fixing it?

I have an Xbox one s is it the same

Here are some suggestions from Xbox Support:

Your screen is blank after you turn on the console

• Confirm that both your TV and Xbox One console are turned on.
• Check that your TV is set to the correct input signal (HDMI).
• Check that the HDMI cable connection to your console is secure.
• Check that the HDMI cable connection to your TV is secure.
• Check that the HDMI cable is connected to the "out to TV" port on the console.
  
• Power cycle your Xbox One: Press and hold the Xbox button
  for 10 seconds to turn off the console, and then turn it on again.
• Reset your display settings. Here's how:
  1. If there's a disc in the Xbox One console, eject it.
  2. On the console, press and hold the Xbox button for 10 seconds to turn off the console.
     
  3. Press and hold the Xbox button and the Eject button until you hear a beep to turn on the console. You’ll hear one beep right away and a second beep 10 seconds later. The power light will flash on before the second beep.
     DO NOT LET GO until the second beep occurs.
     
     Note If you have an Xbox One S All-Digital Edition, you’ll need to press and hold the
     Xbox button and the Bind button instead, as your console does not have an
     Eject button.
     
     In either case, this will boot your console in low resolution mode (640 × 480). To reset this setting, press the
     Xbox button to open the guide. Go to System >
     Settings > Display & sound > Video output, and then select the resolution you want from the Display dropdown.
     
  4. If you’re required to complete these steps on every boot-up, you’ll want to change your TV connection to HDMI as shown in step 3 of the next section, "Your screen is blank and you use an AVR in your setup." For more info, see
     
     How to adjust the display settings on your Xbox One.

• Try plugging the HDMI cable into a different HDMI port on your TV.
• Try using a different HDMI cable to connect your console to your TV.
• Try connecting your console to a different TV.

https://support.xbox.com/xbox-one/console/tv-or-monitor-screen-is-blank-while-connected#4c5eb9480e1e4b7f8f10261ef32477c6

hi thanks for the question.

if it was me i would do a power cycle reset.

push a hold the xbox power button till turn off.

then unplug for 5 mins then reconnect and power up.

hope this helps

when the device is powered off, press and hold the power button on the xbox for about 10-15 seconds to power it on as i think this resets the display to the most basic of display settings, this should then let you pick which settings you want again.

Cheers