: How do I put my gateway modem into Bridge Mode?

How do I put my gateway modem into Bridge Mode?

As one had stated, each modem can be different. Usually a call to your Internet Service Provider support and asking them to configure it in Bridge mode is enough to get it up and running in Bridge mode.

But I would only suggest doing this if you're going to use your own router for our network because once a modem is bridged, it no longer supports routing functions.

This article may help with that:

https://support.zen.co.uk/kb/Knowledgebase/Technicolor-TG589vac-Bridge-Mode

Although not the same model, tge actions required may be the same?

How do I put my gateway modem into Bridge Mode?

Should be under your advance setting but ever modems diffrent might google your model #

Hello alantaber,

Thank you for posting on the Xbox forums. We understand that you are interested in learning how to turn bridge mode on for your gateway. Each manufacturer handles

bridge mode differently, so you’ll need to check with your manufacturer or service provider to find out how to do this. If you can’t put your gateway into bridge mode, try changing your router to function only as an access point. This will remove
it as a NAT on your network. Once you’ve changed either your gateway or your router settings, restart your Xbox and your network devices, and then check your network settings again to make sure that the NAT message is gone. We hope this information helps!