Draytek: Port Forwarding

Draytek (Modems/Gateways): Port Forwarding
Draytek- Vigor2500

Login Information:

Default Gateway – 192.168.1.1

Username – *none*

Password – *none*



Port Forwarding

1. Open a web browser.
2. Enter http://192.168.1.1 (or click the link).
   
3. Click the Ok button.
4. Select NAT Setup in the Advanced Setup Section.
5. Select Open Ports Setup.
6. Click on the number of the next available Index.
7. Check the Enable Open Ports box.
8. Enter “Xbox Live” in the comment field.
9. Click the Choose PC button and choose the Xbox from the resulting list.
10. Set Protocol to Both. If both is not available two rules will need to be created one UDP and the other TCP.
    
11. Set both the Start Port and End Port to 3074.
12. Click the OK button.

Disable Port Forwarding

1. Open a web browser.
2. Enter http://192.168.1.1 (or click the link).
   
3. Click the Ok button.
4. Select NAT Setup in the Advanced Setup Section.
5. Select Open Ports Setup.
6. Click the Index number next to the rule that was created.
7. Click the Clear All button.
8. Click the OK button.

:)

 

My NAT type is open but I still can't connect to some people?

Well that is certainly the issue as you are double NATing. To make this work you would have to make quite a few changes to the Netgear.



You would have to turn off NAT and DHCP, and give the Netgear an ip address in the same range as the Draytek and also plug the cable coming from the Draytek into one of the LAN ports of the Netgear instead of the WAN port (I assume its connected to the WAN
port at the moment)



It just gets a bit complicated really, don't you have a phone line close to you to you could swap the positions of the Draytek and Netgear as this NAT issue will only really affect gaming for Xbox PS3 etc, it won't affect browsing/email/msn etc



If you could plug into the Draytek you'd be fine

 

Draytek: DHCP Reservation

Draytek (Modems/Gateways): DHCP Reservation
Draytek- Vigor2500

Login Information:

Default Gateway – 192.168.1.1

Username – *none*

Password – *none*



DHCP Reservation

*Not Available*