Downloaded FS2020 and attached joystick and throttle but they don't work.

This an observation on a PC based version of FS 2020. My Thrustmaster Warthog HOTAS stick and throttle and T-Rudder pedals are supported and work fine. The Saitek Multi Panel, Switch Panel, Radio Panel, Throttle Quadrant, and FIP's do not work in FS2020.
I did get the Prop and Mixture to work correctly on the attached Throttle of the Yoke, but the additional Throttle Quadrant is a no go. All of these pieces are working perfectly in FSX on this same machine, so it is FS 2020 that is the problem. I dug out an
old USB 2040 digital switch. FS 2020 saw that just fine. I hooked up my old "Park Brake" Switch and mapped it in the controls set. It works fine. If they can see old technology like that piece, I wonder how hard it would be to write drivers for the above mentioned
pieces. The 64 bit Windows 10 Saitek drivers work perfectly in FSX on the same machine.

Well in theory i don't think so.

But i think will be possible with FS2020 because it's a flight simulator.

I look on internet and find something about pc but with different joystick.

Actually got is working quite well thanks to your video. However no matter what I try the throttle will only only move either in or out depending on whether or not the setting it is reversed.

Flying with full throttle all the time proves interesting ! And can you tell FS2020 to ignore crashes as in the previous version

Thanks Keith

I spent the last two days exclusively trying to install FS2020 and finally after 16 hours at the computer rebooting and loging off and on and off again and uninstalling re-installing till I was about to GIVE UP AND go back to p3d v4 which is stable and
not as glamorous. when it finally opened and then when I slid the throttle up on my PXN joystick nothing happened and after another 20 minutes it turns out my joystick is not supported I will not buy a new joystick I have cancelled my purchases of BOTH versions
and will not rebuy unless it supports all joysticks this was a STUPID DESIGN, it takes 12 minutes to load on an 8 core I7, and uses 100% of my GPU a raedon WX5100 and still I cannot fly it SO SO SO DISAPPOINTING

So I took your advice and yes, it works. Press the Sensitivity button first and essentially calibrate X, Y and throttle. Then use the "All" tab under "Filter". You then need to select "Ailerons Axis" with input Joystick Axis X from the drop down list, Elevator
Axis to your Joystick Y Axis, and Throttle 1 Axis as Joystick Axis Z.

I also found a
good explainer here.