DEFAULT GATEWAY RESETS AFTER EACH REBOOT

So, i had to set up a static IP to get my NAT open.

everytime i restart my xbox, i need to reconfigure my gateway, it resets to 0.0.0.0. At least it works when i do this, but its a bit of a pain having to do it every single time.

Restore to factory settings has been suggested, this is a very temporary fix.

Anyone have any ideas?

:)

 

Restore Factory Defaults

Login Information

• Gateway – 192.168.0.1
• Username – admin
• Password – password

Restore Factory Defaults



From Firmware:

1. Open up a web browser.
2. Type “192.168.0.1” into the web address bar.
3. A login screen will appear asking for a username and password. See
   Login Information above to login to the gateway.
4. After logging into the gateway, click on “Utilities”.
5. On the right had side, click on “Factory Defaults”.
6. On the main page, click on “Factory Defaults”

From Hardware:

1. Go to the gateway.
2. Look at the back of the gateway, where the ports are located.
3. Locate the reset button.
4. Hold in the reset button for 30 seconds.
5. Wait for 1 min for the gateway to reboot.

 

Restore Factory Defaults

Login Information

• Gateway: 192.168.1.1
• Username: ubnt
• Password: ubnt

Restore Factory Defaults

From Hardware:

1. Locate the back of the device, where the Ethernet port are located.
2. Hold the reset button on the back for 30 seconds. You will need a paperclip, toothpick or pen to hold down the reset button.
   
3. Let go of the reset button and wait about 1 minute for the device to reboot.

From Firmware:

1. Connect a computer to the gateway with an Ethernet cable.
2. Open a web browser on a computer.
3. Type in the gateway address, 192.168.1.1 into the web address bar, hit enter.
   
4. This will take you to a login page, type ubnt for both username and password.
   
5. Once of the main page, select the System tab on the top.
6. Click on the Reset to Defaults… button.
7. The device will reboot back to the default settings after a few minutes.

 

Does your router support DHCP reservation (aka static DHCP IP)? If so, use that instead of setting a static IP on the Xbox One. If you aren't sure, please post the make and model of your router.