Controller and Wireless Headset conflict

Hello, My name is Jesse. I'm an Independent Advisor and a member of the Microsoft community and I'd love to assist you today.

It appears the Bluetooth signal from the headset is conflicting with the signal from the controller. I'll sincerely advise you stick with the wired controller or get a wireless from a different brand like turtle beach or steel series. Sorry for the inconvenience

Turn off and disconnect all controllers from the Xbox 360 and disconnect the wireless headsets from the controllers.

Connect the wireless headset to the Xbox 360 using the USB cable. Turn on the wireless headset.

Sync the headset to quadrant 1 by pressing the "Connect" button on the on the Xbox 360. Then press the "Connect" button on the wireless headset for two seconds. Do not continue to press the "Connect" button on the wireless headset, as this will change the
quadrant to which it is connected. If the headset now works without the controllers attached, the problem must be with one of your controllers. If the headset still does not work, then the problem is with the headset.

Hey there. I assume you're talking about the official Xbox wireless headset. Have you tried the following?

The headset can’t connect to a specific controller

Try the following:

Unplug any wired headsets from the console.

On the wireless headset, press the connect button. Lights on the wireless headset and on the controller are lit when they are connected. If the headset connects to the wrong position on the controller, press the connect button again to switch to the next
available position.

If your headset still won’t connect, try this:

Disconnect all other accessories from the console.

Turn off all wireless controllers:

Press and hold the Guide button on the controller for three seconds.

Confirm that you want to turn off only the controller.

Press the power button on the wireless headset.

Press the connect button on the console.

Press the connect button on the wireless headset. The lights around the console power button will spin and blink once. The position that remains lit is the position of the wireless headset.

If you want to test if the wireless headset will connect to the other positions, press the connect button again. The wireless headset connects to the next position.

My Halo 3 Wireless Headset still works.



The Wireless Headset should always go the the first controller if the controller doesn't have a wired headset plugged in.

are you using a wireless controller/headset?

I assume you use wireless controller as you say youve changed batteries.

what about a wired controller/headset?

if its fine with wired and not through wireless control then theres something not right with the console and its wireless sync with controllers.