Connecting 2 xbox one's to 2 different routers on one modem

Hi,

Belkin f9k1001v1 :

www.belkin.com/.../support-article

https://www.youtube.com/watch?v=jfkrsvUu3ts

Linksys wrt120n :

kb.linksys.com/.../ukp.aspx

https://www.youtube.com/watch?v=dEI0VRAiyrk

Modem smcd3gn :

www.ports3658.com/.../smc-smcd3gn-res-how-to-port-forwarding.html

community.shaw.ca/.../DOC-2365

https://www.youtube.com/watch?v=0Pm1qh2j0qY

or you can try this tool http://portforward.com hope it helps, take care.

Hi,

You may have to make a configuration change to your firewall or network hardware, such as a router, for your Xbox One console to communicate with Xbox Live. This configuration change is sometimes called "opening ports" or "port forwarding." Port forwarding
for Xbox One is done on your router or other network hardware, not on the Xbox console itself.

Xbox Live requires the following ports to be open:

Port 88 (UDP)

Port 3074 (UDP and TCP)

Port 53 (UDP and TCP)

Port 80 (TCP)

Port 500 (UDP)

Port 3544 (UDP)

Port 4500 (UDP)

If you're connected to a network through your workplace or school, ask the network administrator to open these ports.

support.xbox.com/.../network-ports-used-xbox-live

Try to open them all on all devices routers / modem / extender you have.

Downstairs belkin f9k1001v1

Upstairs linksys wrt120n

Modem smcd3gn

Greetings!

[quote user="sabermax"] The modem is upstairs and the 2 routers connected to that 1 up 1 down.[/quote]Appreciate if you can post up the make and model of your modem and your the make and model of both your routers.

[quote user="sabermax"]he 2 routers connected to that 1 up 1 down[/quote]What's the reason for two routers, and are both operating as router/NAT?

May I ask, do you use more than one public IP address? If your gateway only receive one public IP address from your ISP, then I need a bit more information regarding the setup of your networking Equipment.

Modem smcd3gn: This device has to be operating in bridge mode, since an additional router/NAT terminates to this device. In bridge mode, the smcd3gn will operate as a bog standard modem.

Select which one of your two wireless routers that will be the router gateway, for each client computer to connect to. This specific router will perform NAT, DHCP, local DNS server, wireless etc.

The second router, can be configured as an access Point, or a repeater, to extend your existing WLAN.