Can't connect to network

Hey there Spring! It sounds like your console is still stuck on recognizing the old network setup. Try resetting your network settings on your console and then set the connection up from scratch. Below are the steps to do the reset; try them out and let
me know if that helps, thanks!

1. Turn off the Xbox 360 console.
2. If you are using an Xbox 360 Wireless Networking Adapter, unplug it from your console.
   
3. Turn on the console.
4. Press the Guide button on your controller, go to Settings, and select System Settings.
   
5. Select Network Settings.
6. Select Wired Network or the name of your wireless network, if you are prompted to do so.
   
7. Select Configure Network.
8. On the Additional Settings tab, select Restore to Factory Defaults.
   
9. Turn off your console.
10. If you were using an Xbox 360 Wireless Networking Adapter, plug it back into the USB port.
    
11. Turn on the console.
    
    Wireless connection only: You will receive a message to configure wireless settings. Follow the on-screen instructions to connect to your wireless network.
    
12. Test your Xbox LIVE connection. To do this, press the Guide button on your controller, go to Settings, and select System Settings. Select Network Settings, select Wired Network or your wireless network name (if you are
    prompted to do so), and then select Test Xbox LIVE Connection.

It is possible that the storm surge took out your Network port on your Xbox. That can happen, even with surge protectors. If that is the case, you need to send it in for repair.

Hi Icon,

Have you done basic network troubleshooting already?

If you haven't, I recommend unplugging your router and modem for a good 5 minutes and at the same time go ahead and hard reset and power cycle your Xbox. This guide here will help you physically power cycle your Xbox and unplug the power cable:

https://support.xbox.com/xbox-one/console/power-cycle-console.

Try that out and let us know the results!

Go to your computer,go to run,type in: cmd,a window will open click on it,type:ipconfig,the you see your default ip adress it usually 192.168.2.1 192.168.1.1 once you see the ip adress right it down,go to to enternet browser type the ip then on the left
you'll find alot of options click dhcp it asks login just click login without typing anything it logs in then you can change DHCP

so am i, i really have no idea though, simpl ybecause it was working the other day wiht a freinds wireless, then i used a cable to my computer, and my computer has wireless, but it isnt working, it said enable my DHCP but i dont know how, i tried going to
"www.xbox.com/networkhelp" and it doesnt exist anymore, somebody at least tell me how to enable DHCP?