Belkin: Restore Factory Defaults

Belkin (Routers): Restore Factory Defaults
Login Information

• Gateway - 192.168.2.1
• Username - N/A (None)
• Password - N/A (None)

Restore Factory Defaults

Through Firmware

1. Open a web browser.
2. In the address bar at the top, type in 192.168.2.1
3. Input the password and click Login (by default, the password should be left blank).
   
4. Under Utilities near the bottom left select Restore Factory Defaults.
5. Select Restore Defaults.
6. From the main menu expand Advanced Settings.

Through Hardware

1. Plug the computer into a LAN port via an Ethernet cable.
2. Locate the reset button on the device.
3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
4. Wait for lights to turn off then return to normal.

:)

 

Belkin: Restore Factory Defaults

Belkin (Routers): Restore Factory Defaults
Login Information

• Gateway - 192.168.2.1
• Username - N/A (None)
• Password - N/A (None)

Restore Factory Defaults

Through Firmware

1. Plug the computer into a LAN port via an Ethernet cable.
2. Open a web browser.
3. In the address bar at the top, type in 192.168.2.1
4. Click Login in the upper right.
5. Input the password and click Login (by default, the password should be left blank).
   
6. Select Restore Factory Default from the menu on the left under the Utilities section.
   
7. Click the Restore Defaults button.

Through Hardware

1. Plug the computer into a LAN port via an Ethernet cable.
2. Locate the reset button on the device.
3. With paperclip/pen/toothpick hold down the reset button down for 30 seconds.
4. Wait for lights to turn off then return to normal.

 

Belkin: Restore Factory Defaults

Belkin (Modems/Gateways): Restore Factory Defaults
Login Information

• Gateway: 192.168.2.1
• Username: none
• Password: none

Restore Factory Defaults



From Hardware:

1. Locate the back of the device, where the Ethernet ports are located.
2. Hold the reset button on the back for 30 seconds. You will need a paperclip, toothpick or pen to hold down the reset button.
   
3. Let go of the reset button and wait about 1 min for the device to reboot.

From Firmware:

1. Connect a computer to the gateway using an Ethernet cable.
2. Open a web browser on a computer.
3. Type the address “192.168.2.1” into the web address bar.
4. Click on “Submit” when prompted for a password.
5. On the left hand side, under “Utilities” settings, click on “Restore Default Settings”
   
6. Click on the “Restore Factory Defaults” button.
7. A warning message will appear on screen asking if you want to do this? Click “Ok”
   
8. Wait about 1 min for the device to reboot.