Belkin: Changing Wireless Security Type/Disabling

Belkin (Routers): Changing Wireless Security Type/Disabling
Login Information

• Gateway - 192.168.2.1
• Username - N/A (None)
• Password - N/A (None)

Changing Wireless Security Type/Disabling

1. Plug the computer into a LAN port via an Ethernet cable.
2. Open a web browser.
3. In the address bar at the top, type in 192.168.2.1
4. Click Login in the upper right.
5. Input the password and click Login (by default, the password should be left blank).
   
6. Select Security from the menu on the left under the Wireless section.
7. To change or disable the Wireless Security, select the desired Security Mode from the dropdown (Disabled, WPA/WPA2-Personal(PSK), 128-bit WEP or 64-bit WEP).
   
8. If WPA/WPA2-Personal(PSK) is selected, choose the Authentication (WPA-PSK, WPA2-PSK or WPA-PSK + WPA2-PSK) and Encryption Technique (TKIP or AES). WPA2-PSK with AES is recommended.
   
9. Enter the Pre-Shared Key or WEP Key.
10. If WEP security is selected the password will need to be 10 characters in length (if 64-bit) or 26 characters in length (if 128-bit) and can only use 0-9 and A-F.
    
11. If WPA or WPA2 was selected the password can be between 8-63 characters, is case sensitive and can use any character on your keyboard.
    
12. Once the passphrase has been entered select Apply Changes at the bottom of the page.
    

:)

 

D-Link: Changing Wireless Security Type/ Disabling Wireless Security

D-Link (Modems/Gateways): Changing Wireless Security Type/ Disabling Wireless Security
changing wireless security type/ disabling wireless security

 

D-Link: Changing Wireless Security Type/ Disabling Wireless Security

changing wireless security type/ disabling wireless security