Audio Receiver Power Options

myspittle · Oct 19, 2015

My soundbar -- Philips HTL5140B/12 is set up in Device Control, but under Power Options I only have the choice of Toggle power. Are there any plans to add power on/off depending on the state of the xbox for this device?

Thanks.

:)

JoyfulTuna46921 · Oct 19, 2015

X1 keeps reverting to 7.1

Had the same issue when turned off, xbox one audio setting reverts to 7.1 uncompressed. Resolved using Logitech Harmony One controller by changing power on options to: 1>Receiver, 2>TV, 3>Xbox. In summary power on xbox one last.

Daddio6708 · Oct 19, 2015

How do I change A/V Receiver model

Hello,

When I initially set up my Scorpio I entered the model number of Denon A/V receiver so that the Xbox and Kinect could turn the Denon on and off when the Xbox was powered on and off. My Denon failed due to a lightning strike and I replaced it with a different
model which must use different IR codes for its remote controller. When I go to my Xbox's "Settings, then "Power Mode and Start up", then "TV & A/V Power Options", which brings up "Device Power Options", then move the curser over "Audio Receiver" it won't
let me click through to change the model of Audio Receiver. Am I doing something wrong?

Jim

Kenny H. · Oct 19, 2015

I would check the Xbox Feedback site (Xbox Ideas, powered by UserVoice) to see if anyone else has requested this, and if not, create a new suggestion.

Kenny H.

I would check the Xbox Feedback site (http://xbox.uservoice.com) to see if anyone else has requested this, and if not, create a new suggestion.

JoyfulTuna46921

Had the same issue when turned off, xbox one audio setting reverts to 7.1 uncompressed. Resolved using Logitech Harmony One controller by changing power on options to: 1>Receiver, 2>TV, 3>Xbox. In summary power on xbox one last.

SrgtDonut

Thanks, Rezah. However, how do you manually enter a code for an audio receiver?

I did not see any "I don't see my device" option when setting up the audio receiver.

IIx DEZ xII

Hello there!

I am not aware of anyone else having this issue, i have never had it myself

Try following the solutions for Kinect problems here:
support.xbox.com/.../kinect-sensor-solution

If none of that helps then contact Xbox Official Support here:
support.xbox.com/.../contact-us

Hope this helps!

HeroicSaucer315

Hey there! Sorry, between work and the forums being down I couldn't post this till now.

I found another setting that might help.

Go to Settings > Disc and Blu-ray > Choose Let my receiver decode audio

Try that maybe?!

Other options -

- Hard reset the Xbox by holding down the power button on the front of the Xbox for 15 seconds. After the 15 seconds let go of the power button then restart the Xbox.

- Change the Display Settings - If there are at 4K change it to 1080 and then back to 4k

- Check the Advanced (display) Settings - Change the TV connection from Auto to HDMI and then Back to Auto (maybe uncheck the Allow 50Hz) option

- Go back to the Display and sound settings and choose the HDMI Audio back to Stereo and then Back to Bitstream and then the Bitstream format to Atmos

It seems like the Xbox is trying to output the audio option by the sound bar is not detecting the correct format. And maybe trying to toggle some of these options to try and refresh the connection could help.

Same issue no sound

I think my option for this time is pay for a receiver

Audio Receiver Power Options